BRP Cam-am Outlander 6x6 DPS 2015 Manual page 248

Subsection XX (DIAGNOSTIC AND FAULT CODES)
PCODE MODULE
P0685 ECM
P0686 ECM
P0687 ECM
16
DESCRIPTION
diagnosis related to
Accessories or Light relay,
Blown fuse, damaged
Accessory relay
or disconnected relay,
circuit
damaged circuit wires,
damaged connectors or
damaged ECM output pins
diagnosis related to
Accessories or Light relay,
Accessory relay
Blown fuse, damaged
circuit shorted to
or disconnected relay,
ground or open
damaged circuit wires,
circuit
damaged connectors or
damaged ECM output pins
diagnosis related to
Accessories or Light relay,
Accessory relay Damaged relay,
circuit shorted to damaged circuit wires,
battery + damaged connector or
damaged ECM output
pins.
CAUSE
Check fuse
Disconnect Accessory relay
and Lights relay & turn
key switch (on w/lights)
Measure voltage between harness
connector PF1-10E and ground.
(Expected value: 11 to 13 volts)
Measure voltage between harness
connector PF1-6D and ground.
(Expected value: 11 to 13 volts)
Measure resistance from harness
connector: ECM-K2 to PF1-12D
(Expected value: < 2 ohms)
Measure resistance from harness
connector: ECM-K2 to PF1-7C
(Expected value: < 2 ohms)
Measure resistance between
terminals 85 and 86 on the 2 relays.
(Expected value: 70 to 90 ohms)
Check fuse
Disconnect Accessory relay
and Lights relay & turn
key switch (on w/lights)
Measure voltage between harness
connector PF1-10E and ground.
(Expected value: 11 to 13 volts)
Measure voltage between harness
connector PF1-6D and ground.
(Expected value: 11 to 13 volts)
Measure resistance from harness
connector: ECM-K2 to PF1-12D
(Expected value: < 2 ohms)
Measure resistance from harness
connector: ECM-K2 to PF1-7C
(Expected value: < 2 ohms)
Measure resistance between
terminals 85 and 86 on the 2 relays.
(Expected value: 70 to 90 ohms)
Check fuse
Disconnect Accessory relay
and Lights relay & turn
key switch (on w/lights)
Measure voltage between harness
connector PF1-10E and ground.
(Expected value: 11 to 13 volts)
Measure voltage between harness
connector PF1-6D and ground.
(Expected value: 11 to 13 volts)
Measure resistance from harness
connector: ECM-K2 to PF1-12D
(Expected value: < 2 ohms)
Measure resistance from harness
connector: ECM-K2 to PF1-7C
(Expected value: < 2 ohms)
Measure resistance between
terminals 85 and 86 on the 2 relays.
(Expected value: 70 to 90 ohms)
ACTION
vmr2015