BRP Cam-am Outlander 6x6 DPS 2015 Manual page 191

Section 02 ENGINE, CVT AND GEARBOX
Subsection 17 (GEARBOX AND COUPLING UNIT)
SWITCH
SWITCH WIRE
POSITION
BLACK/
2WD
BEIGE
If the resistance is out of specification, replace the
4WD indicator switch.
4WD Indicator Switch Installation
For installation, reverse the removal procedure.
Pay attention to the following details.
Take care do not damage indicator switch threads
during installation.
Apply carefully some
LOCTITE 5910 (P/N 293 800
on threads of indicator switch.
081)
NOTICE
Do not apply Loctite 5910 on switch
plunger, as it will lead to switch malfunction.
ACTUATOR
Actuator Access
To access the actuator, refer to
the following parts:
– Seat
– Console
– RH side panel
– RH footrest panel.
Actuator Test
Check if the 2WD/4WD selector works properly.
REQUIRED TOOL
FLUKE 115 MULTIMETER
(P/N 529 035 868)
Unplug actuator connector.
Turn ignition key ON.
Set emergency engine stop switch to RUN.
Measure voltage as follows.
SWITCH
SWITCH WIRE
POSITION
2WD WHITE/BLUE
4WD WHITE/BLACK
If the selector is out of specifications, check
wires, connectors and replace the selector if nec-
essary.
If the selector is good, check the vehicle harness.
322
RESISTANCE
Engine
Infinite (OL)
ground
BODY
and remove
VOLTAGE
Battery
WHITE
voltage
If the vehicle harness is good, replace the actua-
tor.
Actuator Removal
NOTE: Before beginning any servicing on the ac-
tuator, make sure the vehicle is in 4WD position.
No need to remove engine from vehicle.
Place a drain pan under actuator.
Detach brake master cylinder from frame.
vmr2012-037-006_a
1. Remove retaining screws from master cylinder support
vmr2012-037-007_a
1. Master cylinder moved apart
Remove actuator screws.
vmr2015-123