Tightening Torque - BRP Cam-am Outlander 6x6 DPS 2015 Manual

vmr2012-011-010_a
LH SIDE — PARTS REMOVED FOR CLARITY
1. "Y" exhaust pipe
2. Springs
"Y" Exhaust Pipe Inspection
Check "Y" exhaust pipe for cracks, bending or
other damages. Replace if needed.
"Y"Exhaust Pipe Installation
The installation is the reverse of the removal pro-
cedure.
Install NEW exhaust gaskets.
Properly position exhaust pipe before tightening.

TIGHTENING TORQUE

Head pipe nuts
(rear cylinder)
HEAD PIPE (FRONT CYLINDER)
Front Head Pipe Removal
"Y" EXHAUST PIPE
1. Remove
this subsection.
2. Refer to BODY and remove rear part of RH in-
ner fender to reach head pipe screws.
vmr2013-011
Section 02 ENGINE, CVT AND GEARBOX
13 N•m ± 1 N•m
(115 lbf•in ± 9 lbf•in)
. See procedure in
Subsection 03 (EXHAUST SYSTEM)
vmr2012-011-012_a
1. Remove
3. Remove front head pipe from vehicle.
vmr2012-011-011_a
LH SIDE — PARTS REMOVED FOR CLARITY
1. Head pipe
NOTE: The space to remove the front head pipe
is limited. Remove it without force.
Front Head Pipe Inspection
Check head pipe for cracks, bending or other dam-
ages. Replace if needed.
Check if the rubber support is brittle, hard or oth-
erwise damaged. Replace if needed.
Front Head Pipe Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
Install NEW exhaust gaskets.
TIGHTENING TORQUE
Head pipe nuts
13 N•m ± 1 N•m
(115 lbf•in ± 9 lbf•in)
85