BRP Cam-am Outlander 6x6 DPS 2015 Manual page 31

REQUIRED TOOLS
TEST CAP (P/N 529
035 991)
COOLING SYSTEM LEAK TEST
110 kPa (16 PSI)
If there is no pressure drop after 10 minutes, there
is no leak in the cooling system.
If the pressure drops, check all hoses, radiator,
cylinders and engine base for coolant leaks or air
bubbles.
Engine Coolant Replacement
Engine Cooling System Draining
CAUTION Engine coolant can be very hot.
Coolant draining should be carried out on a
cold engine.
1. Remove gauge support. Refer to
section.
2. Remove cooling system pressure cap.
vmo2012-012-042_a
1. Cooling system pressure cap
3. Unscrew coolant drain plug.
NOTE: Coolant drain plug is accessible from un-
derneath RH footrest panel.
vmr2015-107
Subsection 03 (PERIODIC MAINTENANCE PROCEDURES (650))
VACUUM/PRESSURE
PUMP
(P/N 529 021 800)
BODY
sub-
Section 01 MAINTENANCE
vmr2015-107-005_a
SOME PARTS REMOVED FOR CLARITY
1. Coolant drain plug
4. Drain cooling system into a suitable container.
5. Disconnect the lower radiator hose and drain
the remaining coolant.
NOTE: Take note of the hose clamp position be-
fore it is loosened for hose removal.
6. Reinstall coolant drain plug with a NEW sealing
ring.
7. Tighten coolant drain plug to specification.
COOLANT DRAIN PLUG
Gasket
Tightening torque
8. Fill cooling system with recommended coolant,
COOLING SYSTEM FILLING AND
refer to
BLEEDING
procedure.
Engine Cooling System Filling and Bleeding
1. Remove cooling system pressure cap.
2. Remove RH and LH side panels. Refer to
BODY
subsection.
3. On LH side of engine, remove outer exhaust
heat shield. Refer to
section.
NEW
10 N•m ± 1 N•m
(89 lbf•in ± 9 lbf•in)
EXHAUST SYSTEM
sub-
21