Fuel Hose And Oetiker Clamps - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Section 04 FUEL SYSTEM
Subsection 02 (FUEL TANK AND FUEL PUMP)
PROCEDURES
FUEL HOSE AND OETIKER
CLAMPS
Fuel Hose Replacement
When replacing fuel hoses, be sure to use hoses
and clamps as available from BRP parts depart-
ment. This will ensure continued proper and safe
operation.
WARNING
Use of fuel lines other than those recom-
mended by BRP may compromise fuel sys-
tem integrity.
WARNING
Whenever removing a hose in the fuel sys-
tem, always use new Oetiker clamps at as-
sembly. Then validate fuel system tightness
by performing a fuel pressure test.
Oetiker Clamp Replacement
REQUIRED TOOL
OETIKER PLIERS
(P/N 295 000 070)
FUEL TANK
Fuel Tank Draining
Remove fuel tank cap and siphon gas into an ap-
proved fuel container.
Fuel Tank Removal
1. Drain fuel tank. Refer to
in this subsection.
2. Remove the fuel pump relay fuse (F15) in the
front fuse box.
396
FUEL TANK DRAINING
vmr2012-028-006_b
1. Fuel pump relay fuse
3. Release fuel pressure by running engine until it
runs out of gas.
4. Disconnect and remove the battery, refer to
CHARGING SYSTEM
5. Remove the rear body panels, refer to
subsection.
EXHAUST SYSTEM
6. Refer to
following:
– Muffler assembly
– Muffler/exhaust pipe heat shield.
7. Remove rear frame. Refer to
tion.
8. Disconnect the following from the fuel pump
module:
– Fuel pump electric connector
– Fuel system vent hose
– Fuel pump pressure hose.
vmr2015-130-005_a
1. Fuel pump connector
2. Vent hose
3. High pressure fuel hose
9. Disconnect the positive (+) battery cable from
the starter solenoid.
subsection.
BODY
and remove the
FRAME
subsec-
vmr2015-130