BRP Cam-am Outlander 6x6 DPS 2015 Manual page 45

6. Continue to pump until no more air bubbles ap-
pear in clear hose.
7. Close then tighten bleeder.
BLEEDER
Tightening torque
8. Add recommended brake fluid to MAX. mark.
Do not overfill.
9. Perform bleeding procedure for the other bleed-
ers.
10. Check brakes operation:
– If brakes feel spongy, bleed system again
then carry out the
SURE VALIDATION
subsection.
Brake Fluid Bleeding (Manual Procedure)
NOTE: Brake fluid reservoir must be kept full to
prevent air from being pumped into the system.
1. Connect a clear hose onto bleeder.
2. Pump up system pressure slowly using brake
pedal and/or lever(s) until resistance is felt.
3. Depress and hold brake pedal and/or lever(s).
4. Open bleeder and then close it.
5. Release brake pedal and/or lever(s) slowly.
NOTE: Do not release brake pedal and/or lever(s)
until bleeder has been closed.
6. Repeat procedure until fluid flows out without
any air bubbles.
7. Tighten bleeder.
BLEEDER
Tightening torque
8. Perform bleeding procedure for the other bleed-
ers.
NOTE: To locate all bleeders according to ve-
hicle configuration, refer to
BRAKE CIRCUIT CONFIGURATIONS
and
BRAKES
subsection.
9. Check brakes operation:
– If brakes feel spongy, bleed system again
then carry out the
SURE VALIDATION
subsection.
vmr2015-107
Subsection 03 (PERIODIC MAINTENANCE PROCEDURES (650))
5.5 N•m ± 1.5 N•m
(49 lbf•in ± 13 lbf•in)
BRAKE SYSTEM PRES-
as detailed in BRAKES
5.5 N•m ± 1.5 N•m
(49 lbf•in ± 13 lbf•in)
EXPLODED VIEW
. See
BRAKE SYSTEM PRES-
BRAKES
as detailed in
Section 01 MAINTENANCE
BODY
Seat Latch Inspection and Operation
Ensure seat latch functions properly and that seat
is properly secured when latched.
Rear Cargo Compartment Latch
Inspection and Operation
Ensure cargo compartment latch functions prop-
erly and that compartment panel is properly se-
cured when latched.
FRAME
Frame Inspection
Inspect frame for damages such as:
– Cracks
– Dents
– Twisting
– Deformation
– Corrosion
– Loose fasteners.
Pay particular attention to:
– Front and rear frame extensions (body mod-
ules)
– Underside of frame
– Suspension attachment points
– Engine attachment points.
Tow Hitch Inspection
1. Ensure tow hitch receptacle module is solidly
mounted.
2. Inspect hitch for cracks and other damages.
3. Repair or replace if necessary.
35