Crank Pin Diameter; Crankshaft Assembly - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Section 02 ENGINE, CVT AND GEARBOX
Subsection 13 (BOTTOM END (650))
vmr2007-037-003_a
1. Connecting rod screws
2. Measure crankpin. Compare to inside diameter
of connecting rod big end.
vmr2006-044-038_a
1. Micrometer
2. Crankpin

CRANK PIN DIAMETER

40.009 mm to 40.025 mm
NEW
(1.5752 in to 1.5758 in)
SERVICE
39.990 mm (1.5744 in)
LIMIT
If the crank pin diameter is out of specification,
replace crankshaft.
NOTE: To measure the connecting rod big end di-
ameter, use the OLD connecting rod screws.
3. Install the OLD plain bearings as they were
mounted initially.
4. Carry out the tightening procedure described in

CRANKSHAFT ASSEMBLY

244
in this subsection.
vmr2006-044-039_a
A. Connecting rod big end plain bearing
CONNECTING ROD BIG END DIAMETER
SERVICE LIMIT
If connecting rod big end diameter is out of spec-
ification, replace plain bearings and recheck.
CONNECTING ROD BIG END RADIAL
CLEARANCE
SERVICE LIMIT
If connecting rod big end radial clearance is out of
specification, replace plain bearings and recheck.
Crankshaft Radial Play MAG/PTO Side
Measure crankshaft main bearing journals on
MAG and PTO sides. Compare to inside diam-
eter of MAG and PTO plain bearings, refer to
CRANKCASE
in this subsection.
vmr2006-044-040_a
1. Micrometer
2. Crankshaft MAG side main bearing journal
40.100 mm (1.5787 in)
0.09 mm (.0035 in)
vmr2015-120