Removal And Installation - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Section 02 ENGINE, CVT AND GEARBOX
Subsection 17 (GEARBOX AND COUPLING UNIT)
Tmr2011-016-016_a
1. Marked areas for removal
2. Output shaft oil seal
Before beginning the installation ensure gearbox
is set to PARK position.
Apply grease all around lips of the sealing seal
OIL SEAL SEALING LIPS
Service product
Apply engine oil on outer diameter of oil seal to
avoid damaging it during installation.
Place oil seal on output shaft and install it using
the following tools.
REQUIRED TOOL
OIL SEAL INSTALLER (P/N 529
036 204)
Flat washer (P/N 250 200 102)
M12 x 1.25 x 35 hexagonal screw (P/N 207 683 544)
tmr2011-016-020_a
1. Output shaft oil seal
2. Oil seal installer
3. Flat washer
4. M12 x 1.25 x 35 hexagonal screw
5. Apply engine oil on outer diameter of oil seal
326
PETAMO GREASE GHY
133N (P/N 420 899 271)
GEARBOX
Gearbox Removal
Remove engine from vehicle. Refer to

REMOVAL AND INSTALLATION

dure.
CONTINUOUSLY VARIABLE TRANSMIS-
Refer to
SION (CVT)
subsection to remove following parts:
– CVT cover
– Drive and driven pulleys
– CVT air guide.
Drain gearbox. Refer to
ING PROCEDURE PERIODIC MAINTENANCE
in
PROCEDURES
subsection.
ACTUATOR
Remove , see procedure in this sub-
section.
Unscrew the four (4) nuts that attach the gearbox
to the engine.
Tmr2011-016-038_a
LH SIDE OF ENGINE
1. Nut M8
ENGINE
for the proce-
GEARBOX OIL DRAIN-
vmr2015-123