BRP Cam-am Outlander 6x6 DPS 2015 Manual page 367

PROCEDURES
WHEEL HUB
Wheel Hub Removal
Lift and support vehicle.
Remove the wheel. Refer to
TIRES
subsection.
Remove the following parts:
– Caliper mounting bolts (if applicable), refer to
BRAKES
subsection
– Hub cap
– Cotter pin
– Wheel hub nut
– Belleville washer.
vmr2012-037-003_a
1. Caliper
2. Remove bolts
tmr2011-032-003_a
TYPICAL
1. Cotter pin
2. Wheel hub nut
3. Belleville washer
Remove wheel hub.
vmr2015-139
Subsection 02 (MIDDLE AND REAR FINAL DRIVE)
Wheel Hub Inspection
Remove disk from RH wheel hub as necessary.
Check wheel hub for cracks or other damages.
Check inner splines for wear or other damages.
If any damage is detected on wheel hub, replace
it with a new one.
WHEELS AND
vmr2012-037-004
Wheel Hub Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following:
Apply
drive shaft splines.
Install Belleville washer with its convex side out-
ward.
vmr2012-037-005_a
1. Wheel hub
2. Washer — Convex side here
3. Nut
Section 06 DRIVE SYSTEM
XPS SYNTHETIC GREASE (P/N 293 550 010)
on
481