BRP Cam-am Outlander 6x6 DPS 2015 Manual page 172

Section 02 ENGINE, CVT AND GEARBOX
Subsection 15 (CONTINUOUSLY VARIABLE TRANSMISSION (CVT) (650))
Remove centrifugal lever and both thrust wash-
ers.
Vmr2012-018-024_a
1. Lock nut
2. Centrifugal lever pivot bolt
3. Centrifugal lever
4. Thrust washers
Fixed Sheave
WARNING
Always wear safety glasses to remove spring
sleeves.
Pull and rotate one-way clutch slowly until the
spring sleeves are visible.
vmr2006-021-020_a
1. One-way clutch
2. Fixed sheave
3. Spring sleeve area
Hold both spring sleeves with fingers and carefully
remove them when the one-way clutch is disen-
gaged.
280
vmr2006-021-021_a
1. Springs
2. Spring sleeves
Drive Pulley Cleaning
Clean pulley faces and shaft with fine steel wool
and a dry cloth.
Using a paper towel with the recommended
cleaning solvent, clean:
– Crankshaft tapered end
– Taper inside the fixed sheave of the drive pulley
– Crankshaft threads
– Drive pulley screw threads.
REQUIRED PRODUCT
PULLEY FLANGE CLEANER (P/N 413 711 809)
NOTICE
Avoid contact between cleaner and
crankshaft seal as damage may occur.
Remove all hardened oil deposits that have baked
on the crankshaft and pulley tapered surfaces us-
ing coarse or medium steel wool, and/or sand pa-
per no. 600.
NOTICE
Do not use any other type of abra-
sive.
Reclean mounting surfaces with paper towel and
PULLEY FLANGE CLEANER (P/N 413 711 809)
Wipe off the mounting surfaces with a clean, dry
paper towel.
NOTICE
Mounting surfaces must be free of
any oil, cleaner or towel residue.
.
vmr2015-121