BRP Cam-am Outlander 6x6 DPS 2015 Manual page 294

Section 04 FUEL SYSTEM
Subsection 02 (FUEL TANK AND FUEL PUMP)
2. Place gasket so that it is properly located be-
tween fuel pump and fuel pump mounting neck
on fuel tank.
vmr2015-130-004_a
1. Gasket ring here
2. Fuel pump flange
WARNING
Ensure gasket ring makes good contact all
around fuel pump and fuel pump mounting
neck on fuel tank.
3. Ensure proper fuel pump orientation as in fol-
lowing illustration.
vmr2012-028-007_a
1. Fuel tank pump index
2. Fuel pump index
4. Insert fuel pump retaining nut over the fuel
pressure hose and electrical wiring connector.
5. While firmly holding pump against tank, engage
fuel pump retaining nut on fuel tank flange.
NOTE: If necessary, move the pump in order to
ensure the flange is sitting completely flat on the
tank.
6. Tighten fuel pump retaining nut to specification.
402
TIGHTENING TORQUE
Fuel pump retaining nut
NOTE: To apply the proper torque to the fuel
pump retaining nut, install the fuel pump nut tool
on a torque wrench with it's handle perpendicu-
larly (90°) to the torque wrench.
vmr2008-135-219_a
TORQUE WRENCH PERPENDICULAR TO TOOL HANDLE
Ensure pump is properly aligned with index marks
after nut it tightened to specification.
WARNING
Fuel vapors are flammable and explosive un-
der certain conditions. Use only non-spark-
ing tools. Ensure pump locking ring is fully
engaged.
7. Install fuel pressure hose on fuel pump using a
NEW Oetiker clamp.
8. Install fuel vent tube on fuel pump.
9. Install electrical connector on fuel pump.
10. Install fuel pump relay fuse.
11. Refuel tank and ensure there are no leaks by
FUEL TANK LEAK TEST
performing a
FUEL PUMP PRESSURE TEST
this subsection.
12. Check fuel level sender operation.
FUEL PUMP PREFILTER
(STRAINER)
Fuel Pump Prefilter Replacement
1. Remove FUEL PUMP
MOVAL in this subsection.
29 N•m ± 1 N•m
(21 lbf•ft ± 1 lbf•ft)
and a
as described in
, see FUEL PUMP RE-
vmr2015-130