Battery And Starter Cable Terminals - BRP Cam-am Outlander 6x6 DPS 2015 Manual

smr2009-045-027_a
NOTICE
Before installing wire terminals in
the connector, ensure all terminals are prop-
erly crimped on wires. After installation of
wire terminals in the connectors, ensure they
are properly locked by gently pulling on them
as if to extract them.
FURUKAWA CONNECTOR
Furukawa Connector Application
Voltage regulator/rectifier.
Terminal Removal
1. Remove the secondary lock (plastic insert).
smr2010-050-021_a
Step 1: Remove the secondary lock
2. Carefully insert the
GM TERMINAL EXTRACTOR
between the lock and the pin to
(P/N 12094430)
release the pin.
smr2010-052-003
GM TERMINAL EXTRACTOR (P/N 12094430)
vmr2015-132
Section 05 ELECTRICAL SYSTEM
Subsection 02 (WIRING HARNESS AND CONNECTORS)
smr2010-050-022_a
Step 2: Insert GM terminal extractor tool (P/N 12094430)
3. Gently pull on the wire to extract the pin out the
back of the connector.
smr2010-050-023_a
Step 3: Pull wire to extract pin
NOTICE
connectors, ensure all terminals are properly
crimped on the wires. After installation of the
wire terminals in the connectors, ensure they
are properly locked by gently pushing on them
as if to extract them.
BATTERY AND STARTER CABLE
TERMINALS
Cable Crimping
Carefully strip the wire approximately to 10 mm
(3/8 in) in length, using a wire stripping tool or
sharp blade/knife.
Before installing terminals in the
425