Brake Pads; Caliper Removal - BRP Cam-am Outlander 6x6 DPS 2015 Manual

vmr2012-042-008_a
TYPICAL
1. Caliper screws
6. Place caliper assembly onto a support.
NOTICE
Do not let caliper hangs by the hose
and do not stretch or twist hose.
Caliper Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
Install NEW caliper retaining screws.
Install NEW sealing washers.
Refill and bleed brake system, refer to
MAINTENANCE PROCEDURES
Tighten caliper retaining screws to specification.
TIGHTENING TORQUE
Caliper retaining screws

BRAKE PADS

Brake Pads Replacement
1. Remove caliper, refer to
this subsection.
2. Remove pin retainer securing brake pad pin.
vmr2015-145
PERIODIC
subsection.
61 N•m ± 9 N•m
(45 lbf•ft ± 7 lbf•ft)

CALIPER REMOVAL

in
Section 07 CHASSIS
Subsection 06 (BRAKES)
vmr2012-042-009_a
1. Pin retainer
3. Remove brake pad pin from caliper.
vmr2012-042-010_a
TYPICAL
1. Brake pad pin
4. Carefully remove brake pads.
5. Clean pistons end using
PARTS CLEANER (USA) (P/N 219 701 705)
6. Push caliper pistons inward.
NOTE: To avoid damaging pistons, use an old pad
to push it into the caliper using a C-clamp.
7. Ensure brake pad spring is properly positioned
onto caliper and not damaged.
XPS BRAKES AND
.
563