BRP Cam-am Outlander 6x6 DPS 2015 Manual page 255

PCODE MODULE
P3002
SCM-LTD
P3003 SCM-LTD
P3004 SCM-LTD
P3005 SCM-LTD
U0073 DPS
vmr2015
Subsection XX (DIAGNOSTIC AND FAULT CODES)
DESCRIPTION
Pressure did not drop to
desired set point after
predefined delay
Release valve Release valve
activation delay momentary blocked
exceeded Blown valve fuse
Damaged circuit
wires or connectors
Faulty valve block
Faulty SCM
System high
Leak in the system
leakage detected
Bad checksum
of Calibration Lost of power on reflash
memory section
Communication
Lost of CAN
network
communication
disconnected
Damaged circuit wires or
CAN bus off, no
messages damaged DPS pins.
CAUSE
1- Go to Activations - SCM and start
Test routine. If the test passed, the
system is working properly. Check
the harness and connection to see
a potential source of intermittent
dysfunction, if nothing is found clear
the occurred fault and no more
actions have to be done. Mud,
dust or water in the release valve
may explain the fault code. If the
Test status shows a Fail_release,
proceed to next action step.
2-Verify the release valve
for obstruction. If nothing is
found go to next action step.
3- Unplug the valve connector and
verify that 12V is present between
pin 1 of the connector on the SCM
side and the battery negative post.
If not, verify the valve fuse and
relay (refer to schematics for more
information). Verify the harness
and the connection between the
valve and the SCM. If everything
is fine, go to next action step.
4- Verify the release valve activation
by disconnecting the valve block
electrical connector and applying
12V across pin 1 and 2 on valve
connector. If the release valve
is operating, change the SCM,
otherwise change the valve block.
1- Verify suspension system for air
leaks
If an update file is available reflash
the SCM, if not clear the fault, if it
returns, replace the SCM.
1- Verify if all the module
are present in BUDS (under
Module Menu), if they are the
vehicle is working properly.
2- Check continuity between the
cluster, ECM and SCM CAN network.
Disconnect MPI2 from DB connector.
Measure resistance between
DB-1 and DB-2 (Expected
value = 50 to 70 ohms).
Measure resistance
between DB-1 and DPS1-C
(Expected value < 5 ohms).
Measure resistance between DB-2
and DPS1-D (Expected value < 5
ohms).
ACTION
23