Rocker Arm - BRP Cam-am Outlander 6x6 DPS 2015 Manual

– Air escaping into crankcase area means exces-
sively worn cylinder and/or broken piston rings.
– Air/oil escaping from crankcase means dam-
aged gasket and/or loosened screws (refer to
BOTTOM END
subsection).
NOTE: For all the checkpoints mentioned above,
see the appropriate engine section to diagnose
and repair the engine.
Reassembly
Reverse the preparation procedure. Ensure to
respect torque values and use of appropriate
products/lubricants. Refer to exploded views in
other subsections of this manual as required.
PROCEDURES
VALVE COVER
Valve Cover Access
Front Cylinder
BODY
Refer to and remove:
– RH side panel
– Rear part of RH inner fender.
vmr2012-011-012_a
1. Rear part of RH inner fender
Rear Cylinder
BODY
Refer to and remove:
– RH side panel
– LH side panel.
EXHAUST SYSTEM
Refer to
pipe.
Valve Cover Removal
Remove valve cover screws.
vmr2015-117
Section 02 ENGINE, CVT AND GEARBOX
and remove exhaust
Subsection 09 (TOP END (650))
tmr2011-013-006_a
TYPICAL — FRONT CYLINDER SHOWN
1. Valve cover screws
2. Valve cover
Remove valve cover and gasket.
2
R400motr53A
1. Valve cover
2. Gasket
Valve Cover Inspection
Check the gasket on the valve cover if it is brittle,
cracked or hard. If so, replace the gasket.
Valve Cover Installation
For installation, reverse the removal procedure.
However, pay attention to the following.
Tighten valve cover retaining screws to specified
torque in a criss-cross sequence.
VALVE COVER RETAINING SCREWS
Tightening torque

ROCKER ARM

Rocker Arm Removal
VALVE COVER
Remove
subsection.
1
7 N•m ± 0.8 N•m
(62 lbf•in ± 7 lbf•in)
. See procedure in this
159