BRP Cam-am Outlander 6x6 DPS 2015 Manual page 171

Subsection 15 (CONTINUOUSLY VARIABLE TRANSMISSION (CVT) (650))
tmr2011-015-005_a
1. Governor cup
2. Slider shoes
3. Sliding sheave
4. Guides
NOTE: The following steps are not necessary ex-
cept if roller must be removed. Refer to
TION before proceeding.
2. Remove slider shoes from governor cup arm.
Use a flat screwdriver if necessary.
1
R400motr171A
1. Slider shoe
3. Place the governor cup on a vice to push out the
roller sleeve in the direction illustrated (against
insertion arrow marked on governor cup arm).
Use an appropriate punch (diameter of punch
must be smaller than the diameter of the sleeve
bore in the governor cup arm).
NOTICE
Do not clamp the governor cup in
the vice to push out roller sleeve. Governor
cup will be damaged.
NOTE: Use protection plates to avoid marks
and/or damages to the governor cup.
vmr2015-121
Section 02 ENGINE, CVT AND GEARBOX
NOTICE
Partly worn rollers may cause damage to the
CVT system.
vmr2006-021-015_a
1. Punch
2. Vice
INSPEC-
vmr2006-021-016_a
1. Removal direction
2. Assembly direction
NOTE: Whenever removing a governor cup which
already has two marked boxes, replace it by a new
one.
vmr2006-021-018
Sliding Sheave
Unscrew lock nut and remove centrifugal lever
pivot bolt. This drive pulley is equipped with 6
levers.
Always replace all rollers as a set.
279