BRP Cam-am Outlander 6x6 DPS 2015 Manual page 328

Section 05 ELECTRICAL SYSTEM
Subsection 04 (CHARGING SYSTEM)
+
RD
RD1
-
RD2
vmr2015-134-005_a
TEST CONDITIONS
RD1-3
BACKPROBE PROBE
RD1-3 BAT1 (+)
2. Connect a battery load tester such as the
ULTRA PRO BATTERY LOAD TESTER (P/N 95260)
3. Start vehicle.
4. Ensure proper test conditions.
TEST CONDITIONS
Battery voltage at idle‡
Engine
Load
Time
‡ Required for accurate testing
5. Measure voltage drop.
+
RD
RD1
-
RD2
vmr2015-134-006_a
BACKPROBE PROBE
RD1-3 BAT2 (-)
If voltage drop is above specification, locate and
repair damaged connector/wire.
438
-
Permanent ground
SPECIFICATION
Battery voltage
NAPA
.
Above 12.6 Vdc
Increase to 4000 RPM
As required to decrease
battery voltage to 12 Vdc
15 seconds
-
SPECIFICATION
Under 0.4 Vdc
BATTERY
Battery Information
These vehicles are equipped with a VRLA battery
(Valve Regulated Lead Acid). It is a maintenance-
free type battery.
Refer to battery manufacturer's instructions for
proper filling, activation and routine charging pro-
cedures.
Battery Removal
1. Remove seat.
2. Disconnect BLACK (-) cable first, then the RED
(+) cable.
NOTICE
Always respect this order for re-
moval; disconnect BLACK (-) cable first.
3. Remove battery retaining plate.
vmr2012-032-002_a
TYPICAL
1. Battery retaining plate
2. Retaining plate screws (3)
4. Remove battery.
Battery Cleaning
Clean the battery support, cables and battery
posts using a solution of baking soda and water.
Remove corrosion (if so) from battery cable ter-
minals and battery posts using a firm wire brush.
Rinse with clear water and dry well.
Battery Inspection
Visually inspect battery casing for cracks or any
other damages. If casing is damaged, replace bat-
tery and thoroughly clean battery support with a
water and baking soda solution.
Inspect condition of battery posts, battery sup-
port, holding strap and strap attachment points
and wire terminal lugs.
vmr2015-134