Fuel Pump Removal; Electrical System - BRP Cam-am Outlander 6x6 DPS 2015 Manual

V07I0JA
TYPICAL
NOTE: Place a rag around the throttle cable ad-
juster to prevent the lubricant from splashing.
Add lubricant until it runs out at throttle body end
of the throttle cable.
Reinstall and adjust the cable. Refer to
TRONIC FUEL INJECTION (EFI)
Fuel Tank Vent Breather Filter
Replacement
Ensure breather filter is installed with the flow ar-
row pointing towards the vent inlet check valve.
vmr2015-043-019_c
1. Pressure relief valve flow direction arrow
Fuel System Inspection
1. Visually inspect fuel tank for cracks, wear
marks, signs of leakage or any other damages.
2. Visually inspect fuel system hoses for proper
rooting, cracking, wear marks, signs of leakage
or any other damages.
vmr2015-107
Subsection 03 (PERIODIC MAINTENANCE PROCEDURES (650))
ELEC-
subsection.
Section 01 MAINTENANCE
FUEL TANK LEAK TEST
3. Carry out a
FUEL TANK AND FUEL PUMP
WARNING
All fuel system leaks must be repaired. Dam-
aged, worn or leaking fuel system com-
ponents should be replaced to ensure fuel
system tightness.
Fuel Pump Pressure Test
FUEL TANK AND FUEL PUMP
Refer to
tion for procedure.
Fuel Pump Prefilter Cleaning
1. Remove fuel pump from fuel tank, refer to

FUEL PUMP REMOVAL

FUEL PUMP
subsection.
2. Clean the fuel pump prefilter (strainer) using
recommended service product and low pres-
sure air.
RECOMMENDED SERVICE PRODUCT
XPS BRAKES AND PARTS CLEANER
(P/N 219 701 776)
XPS BRAKES AND PARTS CLEANER (USA)
(P/N 219 701 705)
3. If the fuel pump prefilter is heavily soiled,
clogged or damaged:
– Replace it with a new one. Refer to
PUMP STRAINER REPLACEMENT
FUEL TANK AND FUEL PUMP
– Inspect inside of fuel tank for contaminants.
– Clean fuel tank as required.
– Inspect fuel tank vent breather filter. Re-
place as necessary. Refer to
VENT BREATHER FILTER REPLACEMENT
in this subsection.

ELECTRICAL SYSTEM

Battery Inspection
Visually inspect battery casing for cracks or other
damage. If casing is damaged, replace battery
and thoroughly clean battery rack with water and
sodium bicarbonate (baking soda).
Inspect battery posts condition and battery re-
tainer plate.
For battery testing, refer to
subsection.
, refer to
subsection.
subsec-
FUEL TANK AND
in
FUEL
in the
subsection.
FUEL TANK
CHARGING SYSTEM
27