Maintenance Procedures - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Radiator Removal
1. Drain engine coolant. Refer to

MAINTENANCE PROCEDURES

2. Remove front body module. Refer to
subsection.
3. Disconnect both radiator hoses.
vmr2015-115-104_a
1. Radiator hoses
4. On applicable models, remove the following
plastic rivets.
vmr2012-013-005_a
TYPICAL
1. Plastic rivets
5. Remove upper retaining bolts from radiator.
vmr2015-114
Section 02 ENGINE, CVT AND GEARBOX
Subsection 05 (COOLING SYSTEM (650))
PERIODIC
subsection.
BODY
vmr2012-013-006_a
TYPICAL
1. Upper retaining bolts
6. Disconnect cooling fan connector.
vmr2012-013-007_a
FROM LH SIDE
1. Cooling fan connector
7. Remove cooling fan vent hose from vehicle.
NOTE: Take note of the rooting of vent hose on
vehicle to ease reinstallation.
8. Pull radiator upwards to release it from rubber
bushings.
Radiator Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
Ensure that rubber bushings are properly installed
between frame and radiator.
Ensure that vent hose of the cooling fan motor is
properly rooted as prior to removal.
NOTICE
motor is not properly rooted, the fan motor
may be damaged due to improper venting.
If the vent hose of the cooling fan
103