BRP Cam-am Outlander 6x6 DPS 2015 Manual page 189

Section 02 ENGINE, CVT AND GEARBOX
Subsection 17 (GEARBOX AND COUPLING UNIT)
– Setting tab
– ECM tab.
tmr2011-016-090_a
TYPICAL
1. Read data button
2. Setting tab
3. ECM tab
3. Make sure that gearbox is set to NEUTRAL po-
sition.
4. In the Gear Position Sensor Initialization area,
click on the Reset button.
vmr2012-020-010_a
GEAR POSITION SENSOR INITIALIZATION
1. Reset button
A message will be displayed if the operation is
successful.
5. Close and disconnect B.U.D.S.
NOTE: Do not turn ignition key to OFF and do not
set emergency engine stop switch to STOP.
6. Verify gears engagement.
6.1 With the vehicle on ground and in NEU-
TRAL position, start engine.
6.2 During 4-5 seconds, rev engine to 2500 ±
200 RPM.
6.3 Let engine returns to idle.
6.4 Repeat substeps 6.2 and 6.3 for all other
gear positions.
320
NOTE: The vehicle must be in movement to
complete the procedure on R, H and L posi-
tions.
GBPS Access
To reach the GBPS sensor, refer to
move the following parts:
– Seat
– Console
– RH side panel.
GBPS Input Voltage Tes t
NOTE: Prior to conduct testing, check fault codes
in B.U.D.S.
Back-probe the GBPS connector using
RIGID BACK-PROBE (P/N TP88)
Test as follow:
MULTIMETER PROBE POSITIONS
PIN 1 and PIN 3 of the GBPS connector
If voltage is adequate, check GBPS signal wire.
If there is no voltage, check each GBPS input as
follows.
MULTIMETER PROBE POSITIONS
GBPS connector (pin 1)
and battery ground
GBPS connector (pin 3)
and battery + terminal
If there is no voltage, check wires and connector
pins. Replace or repair defective parts and reset
fault codes.
BODY
and re-
FLUKE
or equivalent.
VOLTAGE
5 volts
VOLTAGE
5 volts
Battery
voltage
vmr2015-123