BRP Cam-am Outlander 6x6 DPS 2015 Manual page 98

Section 02 ENGINE, CVT AND GEARBOX
Subsection 07 (MAGNETO AND STARTER)
Magneto Cover Installation
For installation, reverse the removal procedure.
However, pay attention to the following.
Install a NEW magneto cover gasket.
Apply
DREI BOND SEALING COMPOUND (P/N 420
on stator cable grommet as shown in next
297 906)
illustration.
tmr2011-012-006_a
1. Stator cable grommet (apply Drei Bond sealing compound)
Tighten screws using the following sequence.
vmr2015-030-003_b
TIGHTENING SEQUENCE
MAGNETO COVER SCREWS
Tightening torque
Refill engine with recommended oil.
STATOR
Stator Connector Access
NOTE: The stator is directly connected to the volt-
age regulator/rectifier.
142
10 N•m ± 1 N•m
(89 lbf•in ± 9 lbf•in)
vmr2015-116-002_a
1. Voltage regulator/rectifier
Stator Static Test: Continuity
1. Disconnect the stator connector on the voltage
regulator/rectifier.
2. Set multimeter to .
3. Connect multimeter between YELLOW wires.
4. Read resistance.
TERMINAL
1 and 2
1 and 3
2 and 3
V07G05A
TYPICAL
5. If any reading is out of specification, replace sta-
tor.
6. Re-plug connectors properly.
Stator Static Test: Insulation
1. Set multimeter to .
2. Connect multimeter between any YELLOW
wire (on stator connector) and engine ground.
3. Read resistance.
RESISTANCE @
20°C (68°F)
0.15 - 0.30
YL
YL
YL
vmr2015-116