BRP Cam-am Outlander 6x6 DPS 2015 Manual page 311

Section 05 ELECTRICAL SYSTEM
Subsection 02 (WIRING HARNESS AND CONNECTORS)
Terminal Removal
To remove terminals from connector, proceed as
follows:
1. Using long nose pliers, pull out the secondary
plastic lock from between the terminals.
V01G0OA
TYPICAL — FEMALE CONNECTOR
1. Female lock
V01G0PA
TYPICAL — MALE CONNECTOR
1. Male lock
NOTE: Before pin extraction, push wire forward
to relieve pressure on retaining tab.
2. Insert a 4.8 mm (.189 in) wide screwdriver
blade inside the front of the terminal cavity.
3. Pry the retaining tab away from the terminal
while gently pulling the wire and terminal out
of the back of the connector.
420
V01G0QA
TYPICAL — FEMALE CONNECTOR
1. Retaining tabs
Terminal Insertion
1. For insertion of a terminal, ensure the sec-
ondary plastic lock is removed.
2. Insert terminal through the back of the connec-
tor in the appropriate position, and push it in as
1
far as it will go. You should feel or hear the ter-
minal lock engage.
3. Pull back on the terminal wire to be sure the
retaining tabs are holding the terminal.
4. After all required terminals have been inserted,
the lock must be installed.
1
1
F04H6LA
TYPICAL — CONNECTOR PIN-OUT
1. Terminal position identification numbers
1
1
1
vmr2015-132