Handlebar Cover - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Section 07 CHASSIS
Subsection 02 (STEERING SYSTEM)
vmr2008-068-009
TYPICAL — REAR OF WHEEL
11. Calculate the difference between the front
and rear measurements and compare with
following specification.
SPECIFICATION
0 mm to 3 mm (0 in to .118 in) toe-in
12. If the wheel toe measurement is out of spec-
ification, carry out the following:
12.1 Loosen tie-rod end lock nuts.
12.2 Adjust tie-rod length.
NOTE: For a toe-in adjustment, the dis-
tance must be longer at the front of the
wheel. Lengthen tie-rod to increase toe-in,
and vise-versa.
The maximum
length must
(1-1/4 in) Tie rod unengaged length
must be the same at both ends of the
tie-rod.
tmr2011-034-107_a
A. Maximum unengaged length
12.3 Tighten tie-rod end lock nuts to specifica-
tion.
TIGHTENING TORQUE
Tie-rod end
locking nut
13. Repeat procedure for other front wheel.
502
WARNING
unengaged tie-rod
not exceed 32 mm
34 N•m ± 2 N•m
(25 lbf•ft ± 1 lbf•ft)
PROCEDURES
HANDLEBAR GRIP
Handlebar Grip Removal
If equipped with heated grips, refer to
PACKAGE
subsection.
1. Loosen the screw at the end of handlebar grip.
2. Remove the handlebar grip cap.
3. Cut and remove the handlebar grip.
Handlebar Grip Installation
1. Remove all rubber residues of the old grip be-
fore installing the new.
2. Clean the handlebar with
CLEANER (P/N 413 711 809)
any greasy matter on it.
3. Install handlebar grip by blowing compressed
air between handle grip and handlebar.
4. Install a
SMOOTHFLOW™
(P/N 16 GA #511 RTT-B)
bottle of
LOCTITE 406 (GLUE) (P/N 293 800 100)
5. Lift a part of the grip using a small screwdriver
and inject glue (about 4 spots per side).
NOTE: The glue dries quickly. Do not apply it be-
fore installing grip.
6. Apply pressure on the grip for approximately
30 seconds to set the glue.
7. Install the handlebar grip cap and torque screw
0.4 N•m (3.5 lbf•in).

HANDLEBAR COVER

Handlebar Cover Removal
Unscrew both plastic U-clamps that attach handle-
bar cover to the handlebar.
vmr2006-025-005_a
TYPICAL
1. Plastic U-clamp
OPTION
PULLEY FLANGE
or alcohol to remove
TAPERED TIP
from EFD Inc on a
.
vmr2015-141