BRP Cam-am Outlander 6x6 DPS 2015 Manual page 7

INTRODUCTION
Tittle in bold
indicates category
of information to be
carried out.
Reference to a
specific section
or subsection.
Indicates component
procedures apply to.
Indicates specific
procedure to be
carried out.
typical_txt_2008_en
XVI
TYPICAL PAGE
GENERAL GENERAL
NOTE: The following procedures can be done NOTE: The following procedures can be done
without removing the engine. without removing the engine.
During assembly/installation, use the torque val- During assembly/installation, use the torque val-
ues and service products as in the exploded ues and service products as in the exploded
views. views.
Clean threads before applying a threadlocker. Re- Clean threads before applying a threadlocker. Re-
fer to the fer to the SELF-LOCKING FASTENERS SELF-LOCKING FASTENERS and and
TITE APPLICATION TITE APPLICATION
sections at the beginning of sections at the beginning of
this manual for complete procedure. this manual for complete procedure.
WARNING WARNING
Torque Torque wrench wrench tightening tightening specifications specifications
must be strictly adhered to. must be strictly adhered to.
Locking devices (e.g.: locking tabs, elastic Locking devices (e.g.: locking tabs, elastic
stop nuts, self-locking fasteners, etc.) must stop nuts, self-locking fasteners, etc.) must
be replaced with new ones. be replaced with new ones.
PROCEDURES PROCEDURES
MAGNETO FLYWHEEL MAGNETO FLYWHEEL
Magneto Flywheel Cleaning Magneto Flywheel Cleaning
Clean all metal components in a non-ferrous metal Clean all metal components in a non-ferrous metal
cleaner. cleaner.
CAUTION: Clean magneto flywheel using only CAUTION: Clean magneto flywheel using only
a clean cloth. a clean cloth.
Magneto Flywheel Removal Magneto Flywheel Removal
Remove muffler, refer to the Remove muffler, refer to the EXHAUST SYSTEM EXHAUST SYSTEM
section. section.
Remove acoustic panel. Remove acoustic panel.
Remove rewind starter. Remove rewind starter.
Remove starting pulley no. 2. Remove starting pulley no. 2.
mmr2008-001
Bold face number following part
name refers to exploded view
at beginning of subsection.
Section 03 ENGINE Section 03 ENGINE
Subsection 09 (MAGNETO SYSTEM) Subsection 09 (MAGNETO SYSTEM)
LOC- LOC-
TYPICAL TYPICAL
1. Starting pulley 1. Starting pulley
NOTE: To remove starting pulley bolts, hold mag- NOTE: To remove starting pulley bolts, hold mag-
neto flywheel with a socket as shown. neto flywheel with a socket as shown.
mmr2007-016-002
TYPICAL TYPICAL
Models Models
Remove the connecting flange retaining the Remove the connecting flange retaining the
rewind starter to the engine housing. rewind starter to the engine housing.
“TYPICAL”
indicates a general
view which may
not represent exact
details.
1 1
Call-outs pertaining
to above illustration.
Illustration always
follows text to which
it applies.
Italic bold face type-
setting indicates a
procedure applicable
to a specific
model(s).
57
vmr2013-002