BRP Cam-am Outlander 6x6 DPS 2015 Manual page 194

Tmr2011-016-014_a
1. Distance sleeve
2. O-ring
Install countershaft oil seal tool.
REQUIRED TOOL
COUNTERSHAFT OIL SEAL
PUSHER (P/N 529 036 222)
vmr2012-020-005_a
1. Countershaft oil seal
2. Oil seal pusher
Shift Shaft Oil Seal
The shift shaft oil seal can be removed without
removing the gearbox from the vehicle.
To replace the shift shaft oil seal, refer to
and remove:
– Seat
– Console
– RH side panel
– RH footrest panel
– Shift plate from shift shaft (refer to
vmr2015-123
Section 02 ENGINE, CVT AND GEARBOX
Subsection 17 (GEARBOX AND COUPLING UNIT)
Use a suitable tube with the proper diameter to
install the oil seal.
If gearbox housing is apart, use following tools for
shift shaft oil seal installation.
OIL SEAL INSTALLER
(GEARBOX) (P/N 529 035 758)
HANDLE (P/N 420 877 650)
NOTICE
ing lip toward gearbox.
Shift Drum Shaft Oil Seal
To replace the shift drum shaft oil seal, remove
the GBPS (GEARBOX POSITION SENSOR)
procedure in this subsection.
Use a suitable tube with the proper diameter to
install the oil seal.
NOTICE
ing lip toward gearbox.
Output Shaft Oil Seal
To replace the output shaft oil seal, proceed as fol-
lows:
Remove propeller shaft. Refer to
subsection.
Tmr2011-016-015_a
BODY
1. Shift shaft oil seal
2. Shift drum shaft oil seal
3. Output shaft oil seal
Punch a sharp screwdriver through oil seal for re-
moval.
NOTE: Position screwdriver only in marked areas
to avoid damaging the ball bearing behind oil seal
SHIFTER ).
during removal.
REQUIRED TOOL
Oil seal must be installed with seal-
Oil seal must be installed with seal-
. See
REAR DRIVE
325