BRP Cam-am Outlander 6x6 DPS 2015 Manual page 476

CAUTION Make
squeezed between throttle lever and hous-
ing.
TIGHTENING TORQUE
Throttle Lever Retaining
Screw
4. Verify that throttle lever moves freely.
5. Position throttle lever assembly approximately
10° from horizontal of vehicle for thumb com-
fort.
vmr2015-147-005_a
6. Tightenhousing screws to specification in the
following sequence.
vmr2015-147-004_a
TIGHTENING SEQUENCE
WARNING
Make sure throttle lever operates freely and
returns to its original position once released.
vmr2015-147
sure spring is not
3.5 N•m ± .5 N•m
(31 lbf•in ± 4 lbf•in)
Section 07 CHASSIS
Subsection 08 (OPTION PACKAGES)
TIGHTENING TORQUE
Housing Retaining
Screws
7. Install new locking ties.
Heated Grips Removal
1. Remove the console. Refer to
tion.
2. Remove the handlebar cover. Refer to
ING SYSTEM
subsection.
3. Remove the gauge support. Refer to
GAUGE AND ACCESSORIES
4. Disconnect the heated hand grip connectors
(red wire) located under the air intake duct.
vmr2015-147-002
5. Cut all locking ties.
vmr2015-147-001_a
6. Gently pull the heated hand grip harness out of
the console support.
7. Remove and keep handlebar grip caps
4.8 N•m ± .7 N•m
(42 lbf•in ± 6 lbf•in)
BODY
subsec-
STEER-
LIGHTS,
subsection.
595