Drive Belt; Inspection Procedures; Drive Pulley - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Subsection 15 (CONTINUOUSLY VARIABLE TRANSMISSION (CVT) (650))
CVT COVER SCREWS
Tightening torque

DRIVE BELT

Drive Belt Removal
NOTICE
In case of a drive belt failure, the
CVT, cover, drain reservoir and air outlet must
be cleaned and inspected for obstruction.
CVT COVER
1. Remove
2. Open driven pulley.
REQUIRED TOOL
PULLER/LOCKING TOOL
(P/N 529 036 098)
3. Screw tool in the threaded hole of driven pulley
and tighten to open the pulley.
Vmr2012-018-005_a
1. Puller/locking tool
2. Fixed sheave of driven pulley
4. Slide the belt over the top edge of fixed sheave
to remove it.
Vmr2012-018-006_a
vmr2015-121
7 N•m ± 0.8 N•m
(62 lbf•in ± 7 lbf•in)
.
Section 02 ENGINE, CVT AND GEARBOX
Drive Belt Inspection
For drive belt inspection refer to
INSPECTION in the
PROCEDURES subsection.
Drive Belt Installation
For installation, reverse the removal procedure.
Pay attention to following details.
The maximum drive belt life span is obtained
when the drive belt has the proper rotation direc-
tion. Install it so that the arrow printed on belt
is pointing towards front of the vehicle, viewed
from top.
vmr2007-051-006_a
1. Arrow printed on belt
2. Drive pulley (front)
3. Driven pulley (rear)
4. Rotation direction

DRIVE PULLEY

Drive Pulley Removal
DRIVE BELT
1. Remove
subsection.
2. Prior to removing the drive pulley, mark sliding
sheave and governor cup to ensure correct in-
dexation at reinstallation.
DRIVE BELT
PERIODIC MAINTENANCE
, see procedure in this
277