BRP Cam-am Outlander 6x6 DPS 2015 Manual page 389

Handlebar Cover Inspection
Check covers for cracks or other damages. Re-
place if necessary.
Handlebar Cover Installation
The installation is the reverse of the removal pro-
cedure.
HANDLEBAR
Handlebar Removal
1. Remove handlebar cover.
NOTE: Remove handlebar grips, throttle handle,
brake handle and multifunction switch only if the
handlebar is defective and requires replacement.
2. Remove handlebar mounting screws.
vmr2015-141-001
Handlebar Inspection
Inspect the handlebar for damage, cracks or bend-
ing. Replace if any of these problems is detected.
Handlebar Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
NOTE: Ensure handlebar "U" clamps are tightened
equally (equal distance on each side of clamps).
Tighiten clamp screws to specification
TIGHTENING TORQUE
Clamp nuts
STEERING CONNECTORS
Steering Connector Access
1. Remove gauge support, refer to
GAUGE AND ACCESSORIES
vmr2015-141
31.5 N•m ± 3.5 N•m
(23 lbf•ft ± 3 lbf•ft)
LIGHTS,
subsection.
Section 07 CHASSIS
Subsection 02 (STEERING SYSTEM)
vmr2015-141-002
2. Remove front body module, refer to body sub-
section.
3. Remove dash board support.
vmr2012-033-001_a
1. Dash board support
503