Fault Codes - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Section 03 ELECTRONIC MANAGEMENT SYSTEMS
Subsection 01 (ENGINE MANAGEMENT SYSTEM (EMS))
tomer information, and other engine information,
even when the battery is removed from the vehi-
cle.
Engine RPM Limiter
The ECM will limit the maximum engine speed
when vehicle shifter is in:
– Forward position (Hi and LO individually)
– Neutral position
– Park position
– Reverse position.
The ECM uses the CPS and the GBPS for this
function.
An override switch, on the handlebar, allows the
engine speed to run higher than the RPM limiter
when more power is needed in reverse operation.
LIGHTS, GAUGE AND ACCESSORIES
Refer to
Vehicle Speed Limiter
The ECM will limit the maximum vehicle speed
both in 2WD and in 4WD. For this purpose, the
ECM uses the VSS and the GBPS .
Drowned Mode (Flooded Engine)
If engine is fuel-flooded and does not start, this
special mode can be activated to prevent fuel in-
jection and ignition while cranking. Proceed as fol-
lows to activate it.
With ignition key in ignition switch while engine is
stopped, press and HOLD throttle lever at WOT
position.
Press the start button. The mode is now on.
Releasing throttle lever will bring back the normal
mode.
Monitoring System
The ECM monitors the electronic components
of the fuel injection system and also parts of the
electrical system.
For more information, refer to

FAULT CODES

.
Limp Home Mode
The ECM may automatically set default parame-
ters to the engine management to ensure the ad-
equate operation of the engine if a component of
the fuel injection system is not operating prop-
erly. The engine will operate with reduced per-
formance to protect the engine. In more severe
cases, the engine RPM will be limited, also to pro-
tect the engine.
350
.
DIAGNOSTIC AND
These performance-reduced modes allow the
rider to go back home which would not be oth-
erwise possible. Refer to the
FAULT CODES
subsection.
Diagnostic Mode
The ECM features a self-diagnostic mode when
ignition key is turned on. However, some com-
ponents need the engine to be running so that
they can be monitored. Some problems will turn
on a warning lamp or will set the engine in limp
DIAGNOSTIC AND FAULT
home mode. Refer to
CODES
section for more information.
DIAGNOSTIC AND
vmr2015-125