BRP Cam-am Outlander 6x6 DPS 2015 Manual page 258

Subsection XX (DIAGNOSTIC AND FAULT CODES)
PCODE MODULE
U0400 SCM-XMR
U0400 SCM-LTD
U0426
ECM
U3001 DPS
26
DESCRIPTION
Variant coding Faulty variant coding
failure Faulty programming
Variant coding Faulty variant coding
failure Faulty programming
Invalid Data
Received The Vehicle Immobilizer
From Vehicle could not read the number
Immobilizer of the access key.
Control Module
Lost of power on DPS
that can be caused by
Module improper
damaged circuit wires
shutdown
or damaged DPS pins.
CAUSE
1- Verify in Setting - Vehicle
Configuration page is correctly set up.
2- If Update File is available reflash
the SCM. If not, clear the fault, if it
returns replace the SCM.
1- Verify in Setting - Vehicle
Configuration page is correctly set up.
2- If Update File is available reflash
the SCM. If not, clear the fault, if it
returns replace the SCM.
Check for dirty or oxidized Key
contact. Clean key contact if needed.
Check for broke key contact
Ensure sensor connector
is fully inserted.
Measure resistance between
ECMB-A1 and CC-C
(Expected value < 2 ohms).
Measure resistance between
ECMB-C2 and CC-E (Expected value
< 2 ohms).
Check the two DPS fuses
Ensure DPS connector
is fully inserted.
Check for Damaged tail
light, DPS, Cluster circuit wires
Check for damaged DPS pins.
ACTION
vmr2015