BRP Cam-am Outlander 6x6 DPS 2015 Manual page 173

Subsection 15 (CONTINUOUSLY VARIABLE TRANSMISSION (CVT) (650))
vmr2015-121-002_a
1. Taper of fixed sheave
Only use petrol base cleaner when cleaning slid-
ing sheave bushings.
NOTICE
Do not use acetone to clean bush-
ing.
tmr2011-015-006_a
1. Sliding sheave
2. Bushings
Drive Pulley Inspection
Bushings
For bushing inspection, refer to
in this subsection.
Governor Cup
Check governor cup for cracks or other visible
damage. Replace if necessary.
Roller and Slider Shoe
Check each roller for roundness of external diam-
eter.
Check if rollers move freely.
NOTICE
Whenever replacing rollers and
slider shoes, always replace all rollers and
slider shoes as a set.
vmr2015-121
Section 02 ENGINE, CVT AND GEARBOX
Check slider shoes for visible wear and replace if
damaged.
NOTE: If necessary, use a screwdriver to remove
slider shoes.
1. Roller
2. Slider shoe
A. Roller outer diameter
Centrifugal Lever Pivot Bolt
Measure diameter of centrifugal lever pivot bolt;
replace if out of specification.
SLIDING SHEAVE
1. Centrifugal lever pivot bolt
A. Measure diameter here
Centrifugal Lever
Check bushing diameter in the centrifugal lever for
wear. Replace centrifugal lever if necessary.
vmr2006-021-014_a
ROLLER OUTER DIAMETER
NEW
SERVICE LIMIT
ROLLER INNER DIAMETER
NEW
SERVICE LIMIT
A
R610tran12A
CENTRIFUGAL LEVER PIVOT BOLT DIAMETER
NEW
SERVICE LIMIT
13.70 mm to 13.80 mm
(.539 in to .543 in)
13.20 mm (.519 in)
8.05 to 8.15 mm
(.317 to .321 in)
9.00 mm (.354 in)
1
6.078 mm to 6.100 mm
(.239 in to .24 in)
6.00 mm (.236 in)
281