Connecting Rod Big End Axial Play - BRP Cam-am Outlander 6x6 DPS 2015 Manual

vmr2006-044-036_a
1. Crankshaft timing gears
Crankshaft Axial Play
NOTE: Axial play must be measured before split-
ting the crankcase.
Measure axial play on PTO end of crankshaft using
a dial indicator.
CRANKSHAFT AXIAL PLAY
NEW
SERVICE LIMIT
If axial play is out of specification, replace
crankcase and/or crankshaft.

Connecting Rod Big End Axial Play

Using a feeler gauge, measure between face of
connecting rods and crankshaft counterweight.
If the measurement exceeds specified tolerance,
replace the crankshaft.
vmr2015-120
Section 02 ENGINE, CVT AND GEARBOX
0.200 mm to 0.500 mm
(.008 in to .02 in)
0.600 mm (.024 in)
Subsection 13 (BOTTOM END (650))
vmr2006-044-037_a
1. Crankshaft
2. Connecting rods
3. Feeler gauge
CONNECTING ROD BIG END AXIAL PLAY
0.200 mm to 0.500 mm
NEW
SERVICE LIMIT
Connecting Rod/Piston Pin Clearance
Refer to TOP END subsection.
Connecting Rod Big End Radial Play
NOTE: Prior to removing connecting rod from the
crankshaft, mark big end halves together to en-
sure a correct reinstallation (cracked surface fits
in only one position).
1. Remove connecting rods from crankshaft.
NOTICE
Connecting rod screws are not
reusable. Always discard screws and replace
with NEW ones. It is recommended to install
new plain bearings when reinstalling connect-
ing rods.
(.008 in to .02 in)
0.600 mm (.024 in)
243