Steering Column - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Section 07 CHASSIS
Subsection 02 (STEERING SYSTEM)
Brake Lever Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following:
Tighten brake lever mounting screw to specifica-
tion.
TIGHTENING TORQUE
Brake lever mounting
screw
WARNING
If brake hose was disconnected, bleed brake
BRAKES
system. Refer to

STEERING COLUMN

Steering Column Removal
1. Remove gauge support, refer to
GAUGE AND ACCESSORIES
2. Refer to BODY subsection and remove the fol-
lowing:
– Front body module
– Inner fender panels
3. Remove dash board support.
vmr2012-033-001_a
1. Dash board support
4. Remove the air intake silencer. Refer to
TAKE SYSTEM subsection.
5. Remove handlebar, refer to
MOVAL
in this subsection. Also remove locking
ties and separate wiring harnesses and hoses
from the steering column.
6. Cut the locking tie securing the bellows at the
bottom of steering column near the DPS unit,
and pull the bellows upwards sufficiently to ac-
cess the steering column pinch screw.
506
9 N•m ± 1 N•m
(80 lbf•in ± 9 lbf•in)
subsection.
LIGHTS,
subsection.
AIR IN-
HANDLEBAR RE-
vmr2010-003-016_a
TYPICAL
1. Cut this locking tie
2. Steering column bellows
7. Remove steering column lower pinch screw
and nut. Discard the nut.
vmr2012-039-011_a
SOME PARTS REMOVED FOR CLARITY
1. Steering column
2. Steering column lower pinch screw and nut
3. DPS unit
8. Remove upper half bushing retaining screws
and pull retainer off of half bushings.
vmr2015-141