Ignition Coil - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Section 05 ELECTRICAL SYSTEM
Subsection 03 (IGNITION SYSTEM)

IGNITION COIL

vmr2006-018-100
Ignition Coil Access
BODY
Refer to subsection and remove RH inner
fender panel(s) for access to the ignition coil.
vmr2012-031-002_a
TYPICAL
1. Ignition coil location
Ignition Coil Connector Access
800R Models Without a DPS or Winch
Ignition coil connector is accessible from the RH
side.
All Other Models
Ignition coil connector is accessible from the LH
side.
432
vmr2012-031-003_a
VIEW RH SIDE OF VEHICLE, OUTLANDER XT 1000 MODEL
1. Ignition coil
2. DPS
3. Winch relay
4. Cooling system thermostat (1000 engine)
Remove the LH inner fender panel(s) for access
to the ignition coil connector.
vmr2012-031-004_a
VIEW LH SIDE OF VEHICLE, OUTLANDER XT 1000 MODEL
1. Ignition coil connector
2. DPS
Ignition Coil Installation
Install a new elastic nut and tighten to the speci-
fied torque.
IGNITION COIL RETAINING BOLT
TIGHTENING TORQUE
8 N•m ± 1 N•m (71 lbf•in ± 9 lbf•in)
Ignition Coil Input Voltage Test
1. Disconnect the 3-pin connector from the igni-
IGNITION COIL CONNEC-
tion coil. Refer to
TOR ACCESS
.
vmr2015-133