BRP Cam-am Outlander 6x6 DPS 2015 Manual page 35

vmo2012-012-042_b
1. CVT air filter
CVT Air Filter Cleaning
1. Remove CVT air filter.
2. Inspect filter and replace if damaged.
3. Gently clean filter using a solution of soft soap
and tap water, then rinse thoroughly.
4. Dry filter completely.
5. Clean inside the CVT air inlet duct.
CVT Air Filter Installation
1. Install air filter on CVT inlet.
2. Install gauge support.
Drive Belt Inspection
1. Inspect belt for cracks, fraying or abnormal
wear. Replace if necessary.
2. Check drive belt width at cord level. Replace if
it is out of specification (see table below).
DRIVE BELT WIDTH
SERVICE LIMIT
vmr2006-021-005_a
1. Drive belt
2. Cord in drive belt
vmr2015-107
Subsection 03 (PERIODIC MAINTENANCE PROCEDURES (650))
30 mm (1.181 in)
Section 01 MAINTENANCE
Drive Pulley, Driven Pulley and
One-Way Bearing Maintenance
CONTINUOUSLY VARIABLE TRANSMIS-
Refer to
SION (CVT)
subsection.
FUEL SYSTEM
Throttle Body Inspection and Cleaning
AIR INTAKE SYSTEM
1. Refer to
remove the air filter housing.
2. Visually inspect throttle plate and throttle body
venturi for cleanliness.
3. Clean inside throttle body if necessary. Refer to
ELECTRONIC FUEL INJECTION (EFI)
tion.
Throttle Cable Lubrication
The throttle cable must be lubricated with
LUBRICANT (P/N 293 600 041)
WARNING
Always use a silicone-based lubricant. Using
another lubricant (like a water-based lubri-
cant) could cause the throttle lever/cable to
become sticky and stiff.
Open the throttle lever housing.
V07I0FY
V07I0FB
1. Remove these screws
Separate the housing.
Slide rubber protector back to expose throttle ca-
ble adjuster.
subsection and
subsec-
CABLE
or an equivalent.
1
25