Service Tools; Troubleshooting; Diagnostic Tips - BRP Cam-am Outlander 6x6 DPS 2015 Manual

COMMUNICATION TOOLS AND
B.U.D.S.

SERVICE TOOLS

Description
MPI-2 DIAGNOSTIC CABLE..........................................................
MPI-2 INTERFACE CARD ..............................................................
SERVICE TOOLS – OTHER SUPPLIER
Description
MALE-FEMALE EXTENSION SERIAL CABLE...............................
GENERAL
PROCEDURES
Refer to
communication tools.
If communication problems occur, refer to
BLESHOOTING
in this subsection.

TROUBLESHOOTING

DIAGNOSTIC TIPS

IMPORTANT: Make sure all connections are
made and vehicle is powered up before starting
B.U.D.S. to allow proper communication between
the vehicle and B.U.D.S.
MPI-2 Connection Troubleshooting
MPI-2 Status Lights
The MPI-2 includes 2 status lights that indicate the
connection condition: USB and CAN. Both lights
must be GREEN for the MPI-2 to function prop-
erly. Otherwise, refer to the following charts.
vdd2006-001-151_b
Prerequisite for USB Communication:
– PC Computer turned on.
– MPI-2 connected to PC computer.
vmr2015-127
Section 03 ELECTRONIC MANAGEMENT SYSTEMS
Subsection 03 (COMMUNICATION TOOLS AND B.U.D.S.)
for instructions on the
TROU-
Part Number
710 000 851 ......................................... 355
529 036 018 ......................................... 355
Part Number
DB9 ......................................... 355
USB LIGHT
STATUS WHAT TO DO
Check USB connection between
Light is MPI-2 and PC computer.
OFF
Check USB operation on PC computer
(hardware or Windows drivers)
Connections are GOOD.
Light is
Communication can take place on
GREEN
USB side
Prerequisite for CAN Communication:
– MPI-2 connected to diagnostic connector on ve-
hicle.
– ECM turned on (electrical system powered up
without engine started).
– Ignition key installed and turned to ON.
– B.U.D.S. started and logged on.
CAN LIGHT
STATUS WHAT TO DO
Light is
Check connection between MPI-2 and
OFF diagnostic connector on vehicle
Light is
Check CAN wires/connectors on vehicle
RED
Light is Connections are GOOD. Communication
GREEN can take place on CAN side
Communication Problems when Using
B.U.D.S.
Missing Module
Ensure the appropriate number of modules is
shown at the bottom RH side of B.U.D.S. screen.
Page
Page
353