BRP Cam-am Outlander 6x6 DPS 2015 Manual page 29

2. Install a NEW O-ring on oil filter cover.
3. Install the filter into the cover.
4. Apply engine oil on O-ring and on end of filter.
vmr2006-008-001_a
1. Slightly oil
2. Slightly oil
5. Install the cover on the engine.
6. Tighten oil filter cover screws to recommended
torque.
OIL FILTER COVER SCREWS
Tightening torque
7. Reinstall remaining parts if applicable.
COOLING SYSTEM
Recommended Engine Coolant
COOLANT
Finland,
Norway and
BRP
Sweden
recommended
product
All Other
Countries
Alternative, or
_
if not available
NOTICE
Always use
tifreeze containing corrosion inhibitors specif-
ically formulated for internal combustion
aluminum engines.
vmr2015-107
Subsection 03 (PERIODIC MAINTENANCE PROCEDURES (650))
10 N•m ± 1 N•m
(89 lbf•in ± 9 lbf•in)
LONG LIFE
ANTIFREEZE(F)
(P/N 619 590 204)
LONG LIFE
ANTIFREEZE
(P/N 219 702 685)
Distilled water and
antifreeze solution
(50% distilled
water,
50% antifreeze)
ethylene-glycol an-
Section 01 MAINTENANCE
Engine Coolant Level Verification
WARNING
Check coolant level with engine cold. Never
add coolant in cooling system when engine is
hot.
1. Place vehicle on a level surface.
2. Remove the gauge support. Refer to
subsection.
With the vehicle on a level surface, coolant level
should be between the MIN. and MAX. marks of
the reservoir.
vmo2012-012-042_a
1. Engine coolant reservoir
NOTE: When checking level at temperature
lower than 20°C (68°F), it may be slightly lower
than MIN. mark.
3. Add coolant up to MAX. mark if required.
WARNING
Do not remove the coolant reservoir cap if en-
gine is hot.
4. Use a funnel to avoid spillage. Do not overfill.
5. Properly reinstall and tighten reservoir cap.
6. Reinstall gauge support.
NOTICE
Do not store any objects under the
gauge support.
Engine Coolant Specific Gravity Check
1. Remove gauge support. Refer to
section.
2. Remove pressure cap.
BODY
BODY
sub-
19