BRP Cam-am Outlander 6x6 DPS 2015 Manual page 229

rmr2011-021-050_a
1. Click here
rmr2011-070-002_a
MORE DETAILS PAGE
1. Possible causes related to the selected fault
2. Service actions
3. Operating conditions when fault occurred
MORE DETAILS PAGE DESCRIPTION
ITEM
Possible List the possible causes that
causes triggered the fault
Service List the possible actions to perform
actions to solve the fault
Conditions List the operating conditions of the
engine and/or vehicle when the fault
when fault
occurred was triggered
How to Clear Fault Codes Using
B.U.D.S.
1. Connect vehicle to the latest applicable
B.U.D.S. software. Refer to
TION TOOLS AND B.U.D.S.
2. Click on the Read Data button.
3. Click on the Faults tab.
The fault(s) (occurred state only) can be cleared by
pressing the Clear Occurred Faultsor Clear Fault
buttons in B.U.D.S.
vmr2015-128
Section 03 ELECTRONIC MANAGEMENT SYSTEMS
Subsection 04 (DIAGNOSTIC SYSTEM AND FAULT CODES)
INFORMATION
COMMUNICA-
subsection.
rmr2008-039-009
FAULTS PAGE TAB, CLEAR OCCURRED FAULTS
4. Click YES on the following message box.
vbl2012-007-013
The following message will appear.
vbl2012-007-012
5. Turn ignition OFF and wait until the message
disappears.
This will reset the appropriate counter(s) and will
also record that the problem has been fixed in the
related ECU memory.
NOTE: An active fault code cannot be cleared.
In other words, the problem relevant to the fault
code must be repaired before the fault can be
cleared.
FAULT CODE DIAGNOSTIC
Missing Module
If a module is missing, several fault codes will ap-
pear.
To quickly find which module is missing, perform
the following:
1. Connect vehicle to the latest applicable
B.U.D.S. software. Refer to
TION TOOLS AND B.U.D.S.
2. Click on the Read Data button.
3. Click Module in the menu bar.
4. Look at the list of modules.
5. If a module is not visible, then it is not commu-
nicating through the CAN bus (controller area
network).
COMMUNICA-
subsection.
363