BRP Cam-am Outlander 6x6 DPS 2015 Manual page 135

8. Tighten the chain tensioner screw plug.
CAMSHAFT TIMING GEARS
Camshaft Timing Gear Removal
1. Remove valve cover, refer to
tion.
2. Set applicable piston to TDC ignition and lock
magneto flywheel. Refer to
ING
in this subsection.
3. Remove timing chain tensioner. Refer to
ING CHAIN TENSIONERS
4. Remove camshaft
screws.
tmr2011-045-003_b
TYPICAL
1. Camshaft timing gear retaining screws
2. Camshaft timing gear
5. Remove the camshaft timing gear.
Secure timing chain with a piece of wire.
Camshaft Timing Gear Inspection
Check camshaft timing gear for wear or deteriora-
tion.
If timing gear is worn or damaged, replace it as a
set with the timing chain.
For crankshaft gear inspection, refer to
SHAFT BOTTOM END
in the
Camshaft Timing Gear Installation
For installation, reverse the removal procedure.
Pay attention to the following details.
1. Clean camshaft mating surface and threads
prior to installing camshaft timing gear.
vmr2015-152
TOP END
subsec-
CAMSHAFT TIM-
TIM-
in this subsection.
timing gear retaining
CRANK-
subsection.
Section 02 ENGINE, CVT AND GEARBOX
Subsection 11 (TIMING CHAIN (650))
tmr2011-045-004_a
1. Camshaft mating surface
2. Camshaft screw threads
2. Set applicable piston to TDC ignition position
and install the crankshaft position tool, refer to
CAMSHAFT TIMING
REQUIRED TOOL
CRANKSHAFT TDC
POSITION TOOL
(P/N 529 036 201)
3. Install camshaft timing tool on the cylinder
head.
REQUIRED TOOL
Camshaft timing
toolCAMSHAFT TIMING
TOOL (P/N 529 036 268)
in this subsection.
205