Engine Oil - BRP Can-Am OUTLANDER 400 EFI 2014 Operator's Manual

MAINTENANCE PROCEDURES
vmo2011-006-102_a
ARROW POINTING TOWARDS OUTSIDE
NOTICE
Ensure that all hoses are
properly pushed into fittings in or-
der to avoid disconnecting.
6. Reinstall seat.

Engine Oil

Engine Oil Level
NOTICE
Check level frequently
and refill if necessary.
overfill. Operating
transmission with an improper
level may severely damage engine/
transmission. Wipe off any spillage.
NOTE: While checking the oil level, vi-
sually inspect engine area for leaks.
vmo2008-016-012_a
RH SIDE OF ENGINE
1. Dipstick
______________
108
Do not
the engine/
With vehicle on a level surface and en-
gine cold, not running, check the oil
level as follows:
1. Unscrew dipstick then remove it
and wipe clean.
2. Reinstall dipstick, screw in it com-
pletely.
3. Remove dipstick again and check
oil level. It should be near or equal
to the upper mark.
3
V07C02Y
1. Full
2. Add
3. Operating range
To add oil, remove dipstick. Place a
funnel into the dipstick tube to avoid
spillage.
Add a small amount of recommended
oil and recheck oil level.
Repeat the above procedures until
oil level reaches the dipstick's upper
mark. Do not overfill.
Properly tighten dipstick.
Recommended Engine Oil
For the summer season, use XPS
4-STROKE SYNTH. BLEND OIL (SUM-
MER) (P/N 293 600 121).
For the winter season, use XPS
4-STROKE SYNTHETIC OIL (ALL CLI-
MATE) (P/N 293 600 112).
1
2