BRP Cam-am Outlander 6x6 DPS 2015 Manual page 486

Rear Frame Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
First, fit all the supports, screws and nuts in their
proper places. Start tighten the screws and nuts
only when everything is set in place.
Refill middle drive with recommended oil. Refer
PERIODIC MAINTENANCE PROCEDURES
to
subsection.
Cargo Bed Latch Lever Removal
1. Remove rear side panel and opening lever han-
BODY
dle. Refer to subsection.
2. Remove spring and retaining screws to remove
support.
sfvmr2014-010-109_a
RH SIDE SUPPORT
1. Spring
2. Retaining screws
3. Support
3. Remove retaining screws and separate lever
rods from each other by pulling them out.
sfvmr2014-010-123_a
RH SIDE SUPPORT
1. Retaining screws
Latch Lever Installation
The installation is the reverse of the removal pro-
cedure.
vmr2015-148
Section 07 CHASSIS
Subsection 09 (FRAME)
605