BRP Cam-am Outlander 6x6 DPS 2015 Manual page 32

Section 01 MAINTENANCE
Subsection 03 (PERIODIC MAINTENANCE PROCEDURES (650))
vmr2015-029-202_a
1. Outer exhaust heat shield
4. Remove CVT duct outlet.
vmr2015-029-203_a
1. CVT duct outlet
5. Unscrew bleed screws on thermostat housing
covers of both front and rear cylinders.
vmr2015-107-006_a
RH SIDE OF VEHICLE
1. Front cylinder bleed screw
22
vmr2015-107-007_a
LH SIDE OF VEHICLE
1. Rear cylinder bleed screw
6. Fill cooling system until coolant comes out of
bleed screws.
7. Squeeze the top of the coolant hose between
the radiator and coolant pump several times to
all air is bled from the highest point of the hose.
8. Install bleed screws using NEW gasket rings.
9. Tighten bleed screws to specification.
HOLDING STRIP SCREWS
Gasket
Service product
Tightening torque
BLEED SCREWS
Gasket
Tightening torque
10. Refill coolant tank up to MAX level mark.
11. Install cooling system pressure cap.
12. Run engine at idle with the pressure cap ON
until the cooling fan cycles on for a second
time.
13. Stop the engine and let it cool down.
WARNING
Do not remove the pressure cap if the engine
is hot.
14. Check coolant level in the coolant tank. Refer
ENGINE COOLANT LEVEL VERIFICATION
to
in this subsection.
15. Add coolant if required.
NEW
LOCTITE 243 (BLUE)
(P/N 293 800 060)
4 N•m ± 0.5 N•m
(35 lbf•in ± 4 lbf•in)
NEW
5.0 N•m ± 0.6 N•m
(44 lbf•in ± 5 lbf•in)
vmr2015-107