BRP Cam-am Outlander 6x6 DPS 2015 Manual page 443

Section 07 CHASSIS
Subsection 06 (BRAKES)
PERIODIC MAINTENANCE PRO-
NOTE: Refer to
CEDURES
subsection.
Brake Pedal Verification
NOTE: Do not pump up the brakes repeatedly be-
fore doing the validation.
1. Position force gauge perpendicularly on brake
pedal edge.
2. Position a ruler perpendicularly to brake pedal.
3. Push brake pedal from distance A using force
gauge.
vmr2012-042-007_a
A. Distance to push (refer to table)
4. Read load recorded by the force gauge.
5. Load reading must be as per the following table.
BRAKE PEDAL VERIFICATION
DISTANCE
A
55 mm (2-5/32 in)
6. If load reading is not in accordance with the
specification:
6.1 Perform a brake system inspection and
cleaning.
6.2 Bleed brake system.
PERIODIC MAINTENANCE PRO-
NOTE: Refer to
CEDURES
subsection.
PROCEDURES
BRAKE LIGHT SWITCHES
Brake Light Switch Location
The brake light switch is located on the brake
pedal master cylinder.
560
MINIMUM LOAD
220 N (49 lbf)
vmr2015-145-001_a
BRAKE PEDAL MASTER CYLINDER
1. Brake light switch
2. Brake light switch connector
Brake Light Switch Resistance Test
1. Disconnect brake light switch connector.
2. Check switch operation as follows.
BRAKE LIGHT
SWITCH POSITION
Firmly pushed
Released
If switch is defective, replace with a new one.
If the switch tests good, verify wire continuity
between harness connector and ECM connector.
BRAKE SYSTEMS WIRING DIAGRAM
Refer to
REQUIRED TOOL
ECM ADAPTER TOOL (P/N 529 036 166)
529036166
Brake Light Switch Replacement
Brake Light Switch Located on Brake Lever
1. Disconnect brake light switch connector.
2. Replace brake light switch by a new one.
3. Connect brake light switch connector.
PIN RESISTANCE
Close to 0
1 2
Infinite (OL)
vmr2015-145
.