BRP Cam-am Outlander 6x6 DPS 2015 Manual page 90

vmr2007-034-105_a
5. Remove oil seal from inside of crankcase MAG
side using a pusher tool.
NOTICE
Be careful not to damage the rotary
seal surface in crankcase.
tmr2011-011-011_a
1. Oil seal
2. Machined surface for rotary seal
vmr2015-114
Section 02 ENGINE, CVT AND GEARBOX
Subsection 05 (COOLING SYSTEM (650))
tmr2011-011-012_a
OIL SEAL REMOVAL - VIEW FROM INSIDE CRANKCASE MAG
SIDE
1. Orifices for oil seal removal
Water Pump Shaft and Seals Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
Use tightening torque values specified in the ex-
ploded view.
NOTE: Never apply oil on the press fit area of the
oil seal and rotary seal.
Clean rotary seal surface of any old sealant.
Install oil seal.
REQUIRED TOOL
OIL SEAL PUSHER
(P/N 529 035 757)
HANDLE
(P/N 420 877 650)
When installing the oil seal on the pusher, make
sure the sealing lip points outwards.
Push NEW oil seal in place.
113