Engine Installation - BRP Cam-am Outlander 6x6 DPS 2015 Manual

vmr2012-009-022_a
TYPICAL - RH SIDE
1. Rear propeller shaft screw
10. Slightly lift engine and move it forward to dis-
connect rear propeller shaft from engine.
11. Move rear propeller shaft yoke downwards to
make room.
vmr2012-009-023
TYPICAL
12. Move engine rearward to disconnect front pro-
peller shaft from engine.
13. Remove engine from RH side of vehicle.
vmr2015-025
Section 02 ENGINE, CVT AND GEARBOX
Subsection 01 (ENGINE REMOVAL AND INSTALLATION)
vmr2012-009-024
TYPICAL

ENGINE INSTALLATION

Reverse the removal procedure. However, pay at-
tention to the following.
When installing a part, refer to its applicable
subsection for tightening torques and products
required.
Inspect condition of engine mounts.
Install engine on vehicle.
Install all engine retaining bolts loosely.
Install front and rear propeller shafts. Tighten re-
taining screws to specification.
Tighten engine mounting bolts to specification.
Engine retaining bolts
Reconnect all hoses, adapters and electrical con-
nections.
If applicable, fill engine as per specification with
engine oil. Refer to
PROCEDURE
Fill and bleed cooling system. Refer to
MAINTENANCE PROCEDURE
Check for any leaks.
Install all remaining removed parts.
Test drive vehicle to confirm proper operation.
ENGINE MOUNTS
REPLACEMENT
NOTE: Use the same procedure for the front and
rear engine mounts.
TIGHTENING TORQUE
62.5 N•m ± 7.5 N•m
(46 lbf•ft ± 6 lbf•ft)
PERIODIC MAINTENANCE
subsection.
subsection.
PERIODIC
75