BRP Cam-am Outlander 6x6 DPS 2015 Manual page 257

PCODE MODULE
U0155 ECM
U0155 SCM-XMR
U0167 ECM
U0167 ECM
U0300 ECM
U0400 DPS
vmr2015
Subsection XX (DIAGNOSTIC AND FAULT CODES)
DESCRIPTION
Lost Missing CAN ID
communication
Module internal error
with CLUSTER Damaged circuit wires or
(lost of CAN ID's)
damaged module pins.
Communication
Lost of CAN
network
communication
disconnected
Lost
communication The Vehicle Immobilizer is
with Vehicle reporting an electrical fault
Immobilizer on the communication line.
Control Module
Lost
communication The Vehicle Immobilizer is
with Vehicle reporting an electrical fault
Immobilizer on the communication line.
Control Module
Invalid Security Incorrect ECM
Exchange or CLUSTER,
received Incorrect software version.
Variant Coding
Faulty variant coding
failure Software
Faulty programming
incompatibility
CAUSE
Check for Cluster fault or ECM fault
Measure voltage between harness
connector CL-17 and ground.
(Expected value = 11 to 13 volts)
Disconnect MPI2 from DB connector.
Measure resistance between
DB-1 and DB-2 (Expected
value = 50 to 70 ohms).
Measure resistance between
DB-1 and ECMB-C1
(Expected value < 2 ohms).
Measure resistance between
DB-2 and ECMB-C2
(Expected value < 2 ohms).
Measure resistance between DB-1
and CL-19 (Expected value < 2 ohms).
Measure resistance between DB-2
and CL-18 (Expected value < 2
ohms).
1- Verify if all the module
are present in BUDS (under
Module Menu), if they are the
vehicle is working properly.
2- Check continuity between the
cluster, ECM and SCM CAN network.
Check for dirty or oxidized Key
contact. Clean key contact if needed.
Check for broke key contact
Ensure sensor connector
is fully inserted.
Measure resistance between
ECMB-A1 and CC-C
(Expected value < 2 ohms).
Measure resistance between
ECMB-C2 and CC-E (Expected value
< 2 ohms).
Check for dirty or oxidized Key
contact. Clean key contact if needed.
Check for broke key contact
Ensure sensor connector
is fully inserted.
Measure resistance between
ECMB-A1 and CC-C
(Expected value < 2 ohms).
Measure resistance between
ECMB-C2 and CC-E (Expected value
< 2 ohms).
Install the proper ECM
or CLUSTER on vehicle.
Update security coding using
BUDS
Check in the BUDS Tab
"vehicle configuration" if
the DPS option is checked.
Reflash the DPS with the latest
software
ACTION
25