BRP Cam-am Outlander 6x6 DPS 2015 Manual page 34

Table of Contents

Advertisement

Section 01 MAINTENANCE
Subsection 03 (PERIODIC MAINTENANCE PROCEDURES (650))
NOTE: Running engine at idle is not sufficient, ve-
hicle transmission must be operated.
2. Position vehicle on a level surface.
3. Place a drain pan under the gearbox drain plug
area.
4. Clean drain plug area.
5. Remove magnetic drain plug and sealing ring.
Discard sealing ring.
WARNING
The gearbox oil can be very hot.
6. Remove oil level plug and its O-ring.
NOTE: Allow oil to completely flow out of gear-
box.
vmo2012-012-057_a
1. Magnetic drain plug
2. Oil level plug
Tmr2011-016-005_a
TYPICAL
1. Magnetic drain plug
2. Sealing ring
3. Oil level plug
4. O-ring
7. Clean magnetic drain plug and pay attention to
any debris present on drain plug.
NOTE: Presence of excessive debris provides an
indication of a gearbox problem.
24
8. Reinstall magnetic drain plug with a NEW seal-
ing ring.
DRAIN PLUG
Gasket
Tightening torque
9. Dispose gearbox oil as per your local environ-
mental regulations.
Gearbox Oil Filling Procedure
1. Fill the gearbox through the oil level hole until
the oil reaches the bottom of the oil level hole.
2. Install the oil level plug with its O-ring. Tighten
plug as per table.
OIL LEVEL PLUG
Tightening torque
Vehicle Speed Sensor (VSS) Cleaning
Remove the VSS. Refer to
PLING UNIT
subsection.
Remove all metal particles and oil from the VSS
magnet.
NOTE: A dirty VSS will cause erratic speedometer
readings.
CONTINUOUSLY VARIABLE
TRANSMISSION (CVT)
CVT Air Inlet/Outlet Cleaning
1. Remove CVT cover, refer to
VARIABLE TRANSMISSION (CVT)
2. Inspect and clean the air inlet and outlet open-
ings from inside the CVT cover.
3. Inspect and clean the air outlet duct connected
to the exhaust system heat shield under the
seat.
NOTE: If a lot of debris or grime are found in the
CVT system, it may be necessary to remove the
ducts and thoroughly clean them.
4. Reinstall CVT cover.
CVT Air Filter Cleaning
CVT Air Filter Removal
1. Remove gauge support, refer to
GAUGE AND ACCESSORIES
2. Remove air filter from CVT air inlet by stretching
its sides.
NEW
20 N•m ± 2 N•m
(15 lbf•ft ± 1 lbf•ft)
5 N•m ± 0.6 N•m
(44 lbf•in ± 5 lbf•in)
GEARBOX AND COU-
CONTINUOUSLY
subsection.
LIGHTS,
subsection.
vmr2015-107

Advertisement

Table of Contents
loading

Table of Contents