BRP Cam-am Outlander 6x6 DPS 2015 Manual page 44

Section 01 MAINTENANCE
Subsection 03 (PERIODIC MAINTENANCE PROCEDURES (650))
tmr2011-037-101_a
TYPICAL
1. Caliper bleeder
3. Loosen bleeder.
4. Pump brake lever(s) and/or brake pedal until no
more fluid flows out.
5. Repeat draining procedure for the other bleed-
ers.
NOTE: To locate all bleeders according to ve-
hicle configuration, refer to
BRAKE CIRCUIT CONFIGURATIONS
and
BRAKES
subsection.
Brake Fluid Filling
1. Add recommended brake fluid to MAX. mark.
Do not overfill.
vmo2012-012-046_a
TYPICAL - BRAKE FLUID RESERVOIR
34
EXPLODED VIEW
. See
vmo2012-012-035_a
TYPICAL - UNDER THE SEAT
1. Brake fluid reservoir
NOTE: If applicable, ensure filler cap diaphragm is
fully retracted before closing the cap.
RECOMMENDED BRAKE FLUID
DOT 4 BRAKE FLUID GTLMA DOT4
(P/N 293 600 131)
WARNING
– Use only DOT 4 brake fluid from a sealed
container.
– Do not use brake fluid from an old or al-
ready opened container.
Brake Fluid Bleeding (Procedure Using a
Vacuum Pump)
NOTE: Brake fluid reservoir must be kept full to
prevent air from being pumped into the system.
1. Unscrew all bleeders until brake fluid comes
out then close it.
NOTE: To locate all bleeders according to ve-
hicle configuration, refer to
BRAKE CIRCUIT CONFIGURATIONS
and
BRAKES
subsection.
2. Install the Vacuum/pressure
bleeder.
REQUIRED TOOL
VACUUM/PRESSURE
PUMP
(P/N 529 021 800)
3. Place pump to vacuum position.
4. Pump vacuum pump a few times.
5. Loosen bleeder.
EXPLODED VIEW
. See
pump onto
vmr2015-107