BRP Cam-am Outlander 6x6 DPS 2015 Manual page 457

10. With the assistance of a person, pull front
body module forward.
11. Install front body module on a stable and clean
support.
Front Body Module Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
Tighten front fender screws to specification.
TIGHTENING TORQUE
Screws securing footrest
panels to front fenders
Screws securing front
fenders to frame
REAR BODY PANELS
Rear Body Panels Removal
1. Remove seat and open cargo bed.
2. Remove rear top panel retaining screws and
plastic rivets.
sfvmr2014-010-107_a
1. Plastic rivets
2. Retaining screws
3. Rear top panel
3. Remove retaining screws and remove latch
lever handle.
vmr2015-146
4.5 N•m ± 0.5 N•m
(40 lbf•in ± 4 lbf•in)
4.5 N•m ± 0.5 N•m
(40 lbf•in ± 4 lbf•in)
Section 07 CHASSIS
Subsection 07 (BODY)
vmr2015-146-004_a
4. Remove rear side panel.
vmr2015-146-005_a
5. Remove plastic rivet and the screw securing
rear fender to footrest panel.
sfvmr2014-010-122_a
1. Plastic rivet
2. Screw securing rear fender
6. Detach rear fender from footrest panel by relea-
sing retaining tabs.
575