BRP Cam-am Outlander 6x6 DPS 2015 Manual page 418

vmr2012-039-026_b
1. Extractor nut
2. No space here
8. Install the universal Pitman arm puller over the
Pitman arm and the extractor thrust bearing.
REQUIRED TOOL
PITMAN ARM PULLER
(P/N 529 036 227)
vmr2012-039-028_a
1. Extractor thrust bearing
2. Pitman arm puller
3. Pitman arm
9. Lock the positioning screw by screwing the
lock nut tightly against jig upper bar.
NOTE: Be sure to hold the position screw steady
to prevent its tip from backing off the positioning
adapter.
vmr2015-142
Subsection 03 (DYNAMIC POWER STEERING (DPS))
vbs2011-015-008_a
1. Jig upper bar
2. Positioning screw
3. Lock nut
10. As you hold the positioning screw steady, turn
the extractor nut up to pull the Pitman arm off
the DPS output shaft.
vmr2012-039-029_a
1. Positioning screw (held steady)
2. Extractor nut (turned up )
11. Remove Pitman arm puller.
12. Unscrew positioning screw.
13. Remove Pitman arm from the DPS shaft.
Pitman Arm Installation
1. Install Pitman arm jig in a vise with positioning
screw upward.
Section 07 CHASSIS
533